Click here to make tpub.com your Home Page

Page Title: Responsibility for compliance.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-M-62515(AT)
3.5 Identification and marking.  Identification and marking shall be in
accordance with MIL-STD­130 and shall be permanent and legible (see 4.5.2 and
4.8.2).
3.5.1 Nameplates.  The nameplates shall be marked with the information
specified in figure 1, shall be 0.003- to 0.005-inch thick aluminum foil in
accordance with MIL-P-19834, and shall be permanently mounted.  The marking
shall be black on a light background (see 4.5.2, 4.8.1, and 4.8.2).
3.6 Workmanship.  Workmanship shall be in accordance with high-grade
practices and quality and free of sharp edges, burrs, cracks, corrosion, or
any other defect or feature which is a potential personal hazard to the
operator during normal usage (see 4.5.2 and 4.8.2).
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.  Unless otherwise specified in the
contract or purchase order (see 6.2), the contractor is responsible for the
performance of all inspection requirements as specified herein.  Except as
otherwise specified in the contract or purchase order, the contractor may use
his own or any other facilities suitable for the performance of the
inspection requirements specified herein, unless disapproved by the
Government.  The Government reserves the right to perform or witness any of
the inspections set forth in the specification where such inspections are
deemed necessary to assure supplies and services conform to prescribed
requirements.
4.1.1  Responsibility for compliance.  All items must meet all
requirements of sections 3 and 5.  The inspection set forth in this
specification shall become a part of the contractor's overall inspection
system or quality program.  The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of
assuring that all products or supplies submitted to the Government for
Sampling in quality
acceptance comply wih all requirements of the contract.
conformance does not authorize submission of known defective material, either
indicated or actual, nor does it commit the Government to acceptance of
defective material.
4.1.2 Inspection equipment.  Unless otherwise specified in the contract
(see 6.2), the contractor is responsible for the provision and maintenance of
all inspection equipment necessary to assure that supplies and services
conform to contract requirements.  Inspection equipment must be capable of
repetitive measurements to an accuracy of 10 percent of the measurement
tolerance.
Calibration of inspection equipment shall be in accordance with
MIL-STD-45662.
4.2 Classification of inspection:
a.
First article inspection (see 4.4).
b.
Quality conformance inspections (see 4.5).
1.  Examination (see 4.5.2).
2.  Tests (see 4.5.3).
Control tests (see 4.6).
c.
9

Privacy Statement - Press Release - Copyright Information. - Contact Us