 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-63330 (AR)
3.22 Workmanship. The workmanship requirements of MIL-F-13926
shall be adhered to. Exterior protective surface finishes shall be
free of voids which may effect the protective qualities of the
finish or appearance. Optical surfaces shall be free of scratches
and blemishes which may affect their optical qualities or appearance.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified
in the contract or purchase order, the supplier is responsible for
the performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract or order, the supplier
may utilize his own facilities or any other facilities suitable for
the performance of the inspection requirements specified herein,
unless disapproved by the Government. In addition, the Government
reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to
assure supplies and services conform to prescribed requirements.
4.1.1 General provisions. The component and subassembly
inspection requirements of MIL-F-13926 form a part of the quality
assurance provisions of this specification. Definitions of
inspection terms shall be as listed in MIL-STD-109.
4.2 First article (initial production) approval. The
requirement for first article approval and the responsibility
(Government or contractor) for first article testing shall be as
specified in the contract. The sample for first article approval
tests shall consist of 3 mounts plus 3 each of all items covered by
SQAP. The sample shall be manufactured in the same manner, using
the same materials, equipment, processes, and procedures as used in
regular production. All parts and materials, including packaging
and packing, shall be obtained from the same source of supply as
used in regular production.
4.3 Inspection provisions.
4.3.1 Submission of product. Unless otherwise specified by the
contracting off icer, Inspection lot size, lot formation and
presentation of lots shall be accordance with "Submission of
Product" provisions of MIL-STD-105.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals