 |
|||
|
Page Title:
Contractor furnished inspection equipment. |
|
||
| ||||||||||
|
|  MIL-M-63333(AR)
TABLE III
REQUIREMENTS
TEST PROCEDURE
CONTROL TEST
4.6.1
3.3.1
303.
Storage temperature
(-80 and +160F)
4.6.2, 4.6.9.1
3.3.2, 3.8.1.1
304 l
Periscope locking lever
4.6.2, 4.6.9.2
3.3.2, 3.8.1.2
Shield actuating handle
305.
4.6,2, 4.6.9.3
3.3.2, 3.8.1.3
Handle locking latch
306.
4.6.7
3.6
307.
Sealing
4.6.11.2
3.10.2
308.
Interchangeability-
pressure retention
The tests for Characteristics 304 through 306 inclusive shall be
NOTE:
conducted at -65 and +l5OF. The test for Characteristics 307
and 308 shall be conducted at a temperature between +60 and +90F.
4.4.3 Failure of sample. Should any one item of a special sampling fail
to meet the specified test requirements,-acceptance of the product shall be
suspened by the Government until necessary corrections have been made by the
contractor and resubmitted samples have been approved (see 4.3.3).
4.5 Inspection equipment. Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment in
accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment. Where the contract
provides for Government furnished inspection equipment, supply and maintenance
of test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design. Unless otherwise specified in the contract,
all inspection equipment specified by drawing number in specifications or
SQAP's forming a part of the contract shall be supplied by the contractor in
accordance with technical data listed in the technical data package (TDP).
4.5.2.2 Contractor design. The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
procedures specified in "Examination" and "Test Facilities" requirements of
MIL-F-13926. Since tolerance of test equipment is normally considered to be
within 10% of the product tolerance for which it is intended, this inherent
error in the test equipment design must be considered as part of the
prescribed product tolerance limit. Thus, concept, construction, materials,
dimensions and tolerances used in the design of test equipment shall be so
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals