 |
|||
|
Page Title:
Major assembly parts list-cont. |
|
||
| ||||||||||
|
|  MIL-M-82376B
(3) Modified GFP or CAOE. (N) When GFP or CAOE is modified, the
modification breakdown shall be listed. Any items permanently
removed from the GFP or CAOE shall be listed and annotated as
"Deleted" in column 4 of the MAPL following the modification
breakdown. Columns 1, 2, 3, 4, 5, 6, and 7 of the MAPL shall
be completed for each item deleted (see figures 23 and 24).
d.
Parts/Material. (N) Items of common hardware such as common nuts,
bolts, screws, washers, and fittings, except those of special
design, shall not be listed in the MAPL. Bulk items such as
electrical wire and cable, gasket material, and metal stack, except
those of special design, shall not be listed in the MAPL. All
electrical or electronic parts and all maintenance significant
mechanical parts shall be included in accordance with the
maintenance concept. Hardware and bulk items which are of special
design or modified or fabricated solely for use with the training
device shall be listed in the applicable assembly breakdown.
e.
Column 1, item number. (N) This column shall contain consecutive
item numbers for each item listed. For revisions to the MAPL, new
items shall be added using item numbers with an alpha letter suffix
to retain continuity. Item numbers for deleted items shall remain
with the notation "Deleted" in column 4. If first appearance is
deleted, all detailed information must be transferred to the second
appearance which now will become the master reference for this
item. All other later appearances must refer to the new first
appearance item.
f.
Column 2, reference designations or figure and index number. (N)
This column shall contain reference designation assigned by the
contractor as required by ANSI Y32.16. The unit system for
assignment of reference symbols shall be used. If a reference
designation is not assigned to the item, the appropriate figure and
index number shall be listed.
Column 3, indenture number. (N) An indenture number shall be used
g.
to indicate the relationship of assemblies as follows:
Item No.
Indent.
Description
1
1
End article (complete
training device)
2
2
First major component (unit)
3
3
All parts attached to the first
major component (unit) but not
part of a subassembly thereof
4
3
First assembly
0023E1
29
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals