 |
|||
|
Page Title:
Society of Automotive Engineers |
|
||
| ||||||||||
|
|  MIL-O-52374D
-
Capacitors, Fixed, Electrolytic (Solid Electrolyte), Tantalum,
Established Reliability, General Specification for.
-
Capacitor, Fixed, Ceramic Dielectric (General Purpose),
Established Reliability and Non-Established Reliability,
General Specification for.
-
Resistors, Fixed, Film (insulated), Nonestablished Reliability,
and Established Reliability, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
-
Identification Marking of U.S. Military Property.
-
Electronic and Electrical Component Parts.
-
Dissimilar Metals.
-
DoD Preferred Methods for Acceptance of Product.
DEPARTMENT OF DEFENSE HANDBOOKS
-
Reliability Test Methods, Plans, and Environments for
Engineering Development, Qualification and Production.
(Copies of these documents are available online at http://assist.daps.dla.mil/quicksearch/ or
http://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue,
Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following document forms a part of this document to the extent
specified herein. Unless otherwise specified, the issues of this document are that cited in the solicitation
or contract.
SOCIETY OF AUTOMOTIVE ENGINEERS
-
Nickel Plating (Electrodeposited).
(Copies of this document is available online at http://www.sae.org/ or from the Society of Automotive
Engineers, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Description. The high-voltage oscillator, hereinafter called the oscillator, shall be a solid-state,
electronic device for converting 6.75 volts dc (V dc) input to 2,700 volt ac peak-to-peak output at a
frequency of 1.2 to 2.0 kilohertz (kHz) and shall conform to figure 1 and as specified herein.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals