 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-1407C
3.7.1.2 Tray numbering.- Each tray shall have identification numbering (see
3.3.1.2) stenciled in accordance with MIL-STD-130. The location and height of
the numbering shall be as shown on Drawing 5-7-30.
3.7.1.3 Pin numbering.- Each numbered pin shall be embossed with identifica-
tion number (see 3.3.1.3). The location and height of the numbering shall be
as shown on Drawing 5-7-31.
3.8 Interchangeability.- All component parts of any one unit shall be
fabricated to be interchangeable with the like parts of any other unit furnished
under any one contract,
3.9 Workmanship.- The complete pin set shall be free of sharp edges, burrs,
cracks, splinters, and fractures. Crimped edges of the case shall be tight.
The enamel finish shall be free of runs, thick places, streaks, poor coverage,
wrinkles, and blisters. The pin point shall be sharp and smooth.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.- Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or order, the supplier may use his own or any other
facilities suitable for the performance of the inspection requirements speci-
fied herein, unless disapproved by the Government. The Government reserves
the right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
4.2 Preproduction sample inspection.- When a preproduction sample is
required, it shall be examined for defects as listed in table II and dimensions
specified.
4.3 Inspection.- Sampling for inspection shall be performed in accordance
with MIL-STD-105, except where otherwise indicated hereinafter.
4.3.1 Component and material inspection.- In accordance with 4.1, components
and materials shall be inspected and tested in accordance with all the require-
ments of referenced specifications, drawings, and standards unless otherwise
excluded, amended, modified, or qualified in this specification or applicable
purchase document.
4.3.2 In process inspection.- Inspection shall be made to determine that
surfaces of the carrier case are cleaned and conditioned before painting in
accordance with TT-C-490 and application of primer coating on all surface; of
the carrier case are in accordance with 3.6.2.1. Whenever non-conformance is
noted, correction shall be made to the affected items and lot in process.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals