 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-17881D(SHIPS)
MILITARY (Cont'd.)
MIL-S-22473 - Sealing, Locking, and Retaining Compounds; Single-Component.
MIL-G-24139 - Grease, Multipurpose Quiet Service.
MIL-I-45208 - Inspection System Requirements.
STANDARDS
MILITARY
MIL-STD-167 - Mechanical Vibration of Shipboard Equipment.
MIL-STD-271 - Nondestructive Testing Requirements for Metals.
MIL-STD-278 - Fabrication Welding and Inspection; and Casting Inspection
and Repair for Machinery, Piping and Pressure Vessels in
Ships of the United States Navy.
MIL-STD-438 - Schedule of Piping, Valves, Fittings, and Associated Piping
Components for Submarine Service.
MIL-STD-740 " Airborne and Structureborne Noise Measurements and Acceptance
Criteria of Shipboard Equipment.
MIL-STD-777 - Schedule of Piping, Valves, Fittings and Associated Piping
Components for Surface Ships. -
MS16142 - Boss, Gasket Seal, Straight Thread Tube Fittings, Standard
Dimensions for.
MS18229 - Plug for "O" Ring Gasket.
DRAWINGS
B-153 - Packings and Gaskets, Standard Application of.
B-214 - Root Connections for Attaching Piping.
810-1385850 - Piping, Gage for All Services.
PUBLICATIONS
MILITARY
NAVSHIPS 0900-001-7000 - Fabrication and Inspection of Brazed Piping Systems.
(Copies of specifications, standards, drawings, and publications required by suppliers
in connection with specific procurement functions should be obtained from the procuring
activity or as directed by the contracting officer.)
2.2 Other ublications. The following documents form a part of this specification to
the extent specified herein. Unless otherwise indicated, the issue in effect on date of
invitation for bids or request for proposal shall apply.
NATIONAL BUREAU OF STANDARDS
Handbook H28 - Screw Thread Standards for Federal Services.
(Application for copies should be addressed to the Superintendent of Documents,
Government Printing Office, Washington, D. C., 20402.)
HYDRAULIC INSTITUTE
Test Code of Standards - Centrifugal Pump Section.
(Application for copies should be addressed to Hydraulic Institute, 122 E. 42nd
Street, New York, New York 10017.)
(Technical society and technical association specifications and standards are gener-
ally lvailable for reference from libraries. They are also distributed among technical
groups end using Federal agencies)
3.
REQUIREMENTS
The pumps furnished under this specification shall be products
or listing on the applicable qualified products list at time set
for opening of bids (see 4.2 and 6.5).
3.2 General design. The design and construction of all pumps shall comply with the
space and weight requirements when specified (see 6.1). The pump unit shall be designed to
perform under the list, pitch, roll and trim conditions as specified (see 6.1). Pumps
shall be capable of operating continuously at any point over the entire flow range and the
design conditions as specified (see 6.1).
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals