 |
|||
|
Page Title:
National Electrical Code Handbook |
|
||
| ||||||||||
|
|  MIL-P-44401(GL)
- Data Plate, Transportation Data
5-13-5026
5-13-5028
- Data Plate, Identification, Press Section
(Copies of drawings are available from the U.S. Army Natick Research,
Development, and Engineering Center, ATTN: STRNC-EMSS, Natick, MA 01760-5014.)
2.2 Non-Government publications. The following documents forms a part of this
document to the extent specified herein. Unless otherwise specified, the issues
of the documents which are DoD adopted are those listed in the issue of the
DODISS cited in the' solicitation. Unless otherwise specified, the issues of
documents not listed in the DODISS are the issues of the documents cited in the
solicitation (see 6.2).
NATIONAL FIRE PROTECTION ASSOCIATION
-
National Electrical Code Handbook
NFPA No. 70
(Application for copies should be addressed to the National Fire Protection
Association, 80 Battery March Pike, Quincy, MA 02169.)
(Non-Government standards and other publications are normally available from
the organizations that prepare of distribute the documents. These documents also
may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
REQUIREMENTS
3.
3.1 First article. When specified (see 6.2), a sample shall be subjected to
first article inspection (see 6.3) in accordance with 4.3.
3.2 Alternate components. Components offered as equivalent to components
specified hereinafter and on the referenced drawings as a specific manufacturer's
part or model number or equal, shall be functionally equal to the manufacturer's
model number identified, and of equal or better quality. The incorporation and
inclusion of such a component in the design of the specified end product shall
not require modification or change to any other specified component, and shall
not reduce ease of maintenance to it or any other components, unless such
modification or change is specifically approved by the contracting officer.
Prior to manufacture of the first article, or if none is required, prior to
commencing production, the contractor shall submit for the contracting officer's
approval, a list identifying each proposed alternate component, together with
proof that each listed component complies with requirements specified above. The
contracting officer, at his option, may require a physical sample of the proposed
substitution. Approval of the submitted listing, together with the necessary
supporting data, authorizes commencement of manufacture but does not relieve the
contractor of responsibility that these components perform in accordance with
specified requirements when incorporated into the end product.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals