 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-45969B (AR)
3.7 Distribution box. The distribution box shall be supplied as
a separate unit in a weather resistant case as specified on Drawing
F12007200. Accessory cable and hose assemblies shall be stored in the
case cover.
3.8 Internal accessibility. All doors and adjustable louvers of
the power supply shall be free from binding and shall be easy to
operate with one hand. The rear housing assembly shall be easily
removable by two men by disconnecting fasteners and lifting or sliding
the entire assembly off the remainder of the power supply assembly.
3.9 Electromagnetic interference. The power supply shall meet
the requirements of MIL-STD-461 for Class IIB equipment, Table II.
3.10 Nameplate. An engraved, or etched, metal or plastic
nameplate containing the information described on the applicable
drawings shall be permanently attached to the hydraulic source box
adjacent to the item or function it identifies.
3.11 Electrical components. All electrical components shall be
mounted on the control panel as specified on the applicable drawings.
3.12 Fungus control. Electrical components and circuit elements
shall be treated for fungus resistance in accordance with Type II
requirements of MIL-T-152, except that the statement of treatment
shall not be required.
3.13 Wiring. All wiring in the control panel and cable assembly
shall be in accordance with Drawing 7792555.
Soldering shall be in accordance with MIL-STD-
3.14 Soldering.
454, Requirement 5.
3.15 Air transportability.
3.15.1 Tie-downs. Tiedown connections shall be provided for
securing the power supply during air transport. The connections shall
withstand, without weld failure or permanent deformation, the
following forces applied independently:
Fore
3g
Aft
1-1/2 g
Lateral
1-1/2 g
2g
Up
Down
4-1/2 g
Note: One g shall be equal to the dry cargo weight of the power
supply.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals