 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-46322B(MU)
III - Cont'd
TABLE
MIL-M-13508
Optical element aluminized surface
309.
Optical element polished surface
MIL-O-13830
310.
MMM-A-131
Optical element adhesive
311.
3.2
Applicable dwgs (see 3.1)
General specification
312.
and MIL-F-13926
("a" through "e")
4.5 Inspection equipment.- Except as otherwise provided for by the
contract, the contractor "shall supply and maintain inspection equipment in
accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment.- Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design.- Unless otherwise specified in the contract,
all inspection equipment specified by drawing number in specifications
forming a part of the contract shall be supplied by the contractor in
accordance with technical data listed in the List of Inspection Documents
(IEL) when provided with the technical data package (TDP).
4.5.2.2 Contractor design.- The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
procedures specified in "Examination" and "Test Facilities" requirements
of MIL-F-13926. Since tolerance of test equipment is normally considered
to be within 10% of the product tolerance for which it is Intended, this
inherent error in the test equipment design must be considered as part
of the prescribed product tolerance limit. Thus, concept, construction,
materials, dimensions and tolerances used in the design of test equipment
shall be so selected and controlled as to insure that the test equipment
will reliably indicate acceptability of a product which does not exceed
90% of the prescribed tolerance limit, and permit positive rejection when
non-conforming. Construction shall be such as to facilitate routine cali-
bration of test equipment.
4.5.2.3 Inspection equipment design requirements.- Special test equip-
ment in Table IV, comparable to referenced drawings and having at least the
accuracy depicted thereon, shall be provided. It shall be utilized to con-
duct periscope and component tests related to the examination listed herein.
TABLE IV
TEST EQUIPMENT
DRAWING
EXAMINATION
Fixture, Pressure Tester - Two Station
F8565556
Periscope (only)
Fixture, Vibration
F7560085
Periscope (only)
Adapter, Vibration Fixture
F7645543 & Periscope (only)
F7560085
Milli-dioptometer
D7560124
Periscope and
components
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals