Preservation and packaging of
5.1 Preservation and packaging.
the Housing, Timing and Fuzing shaLL
be in accordance with Dwg.
5.2 Packing. The Housing, Timing and Fuzing shall be packed in
accordance with Dwgs. 9313636 and 9313638.
5.3 Marking. Marking of the box for the Housing, Timing and
Fuzing shall be in accordance with Dwg. 9313636.
5.4 Shipping. When shipments of units from more than one lot
are made at one time, each lot shall be kept separate, and the
division between lots clearly indicated to-prevent mixing of the
lots in transit.
(This section contains information of a general or explanatory
nature that may be helpful, but is not mandatory)
6.1 Intended use. The Housing, Timing and Fuzing covered by
this specification is intended for use in the munition for
Projectile, 155MM, M692/M731.
Acquisition documents must
6.2 Acquisition requirements.
specify the following:
Title, number, and date of the specification.
b. Issue of DODISS to be cited in the solicitation, and if
required, the specific issue of individual documents referenced in
(See MIL-A-48078). Distribution of data cards
6.3 Data cards.
shall include the following:
Commander, US ARDEC, ATTN:
SMCAR-QAT-M (D), Picatinny Arsenal, New Jersey 07806-5000.
6.4 Submission of inspection equipment designs for approval.
See MIL-A-48078. Submit equipment designs as required to Commander,
US Army Armament Research Development and Engineering Center, ATTN:
SMCAR-QAT-M (D), Dover, New Jersey 07801-5000. Request that letter
of submittal state contractor, contract number, specification
number , item nomenclature and classification of defects or test
paragraph. This address will be specified on the Contract Data
Requirements List, DD Form 1423 in the contract.