required to rotate Eccentric 10516549 through a minimum of one full revolu-
tion in each direction shall not exceed 30 oz-ins when checked at standard
temperature. When checked at the temperature conditions specified in
3.4.2, the running torque shall not exceed 50 oz-ins.
18.104.22.168 Filter assembly - Daylight.- This requirement shall be
met at standard temperature and the temperature conditions specified in
3.4.2. Handle 10516536 shall be manually operable to position each of
the four filters in the field of view.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.- Unless otherwise specified in
the contract or purchase order, the supplier is responsible for the per-
formance of all inspection requirements as specified herein. Except as
otherwise specified, the supplier may utilize his own facilities or any
other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set
forth in the specification where such inspections are deemed necessary
to assure supplies and services conform to prescribed requirements.
4.1.1 General provisions.- The component and subassembly inspection
requirements of MIL-F-13926 form a part of the quality assurance provisions
of this specification. Definitions of inspection terms shall be as
listed in MIL-STD-109.
4.2 First article (initial production) approval.- The requirement
for first article approval and the responsibility (Government or contractor)
for first article testing shall be as specified in the contract. The
sample for first article approval tests shall consist of three periscopes
plus three (3) each of all items covered by SQAP. The sample shall be
manufactured in the same manner, using the same materials, equipment,
processes, and procedures as used in regular production. All parts and
materials, including packaging and packacing, shall be obtained from the
same source of supply as used in regular production.
4.2.1 Government testing.- When the Government is responsible for
conducting first article approval tests, the contractor, prior to sub-
mitting the sample to the Government, shall inspect the sample to insure
that it conforms to all the requirements of the contract and submit a
record of this inspection with the sample, including certificates of
conformance for materials.
4.2.2 Contractor testing.- When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected
by the contractor for all the requirements of the contract. The sample
and a record of this inspection, including certificates of conformance
for materials, shall be submitted to the Government for approval. The
Government reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.