Assurance Provisions (SQAP) listed in the technical data
package (TDP). In the absence of SQAP's the applicable Quality
Assurance Provisions of MIL-F-13926 shall apply.
220.127.116.11 Final acceptance inspection. -Subsequent to first
article approval, examination and test related to Section 3
herein shall be performed on a single defect (individual
characteristic) basis in accordance with MIL-STD-105,
Inspection level II, and the sampling plans specified in Tables
II, III, and IV herein. Examination and test for packaging and
marking shall be in accordance with MIL-P-14232 and Section 5
herein. The tabulated classification of defects in Tables II,
III and IV shall constitute the minimum inspection to be
performed by the supplier after first article approval and
prior to Government acceptance or rejection by item or lot.
18.104.22.168 Functional tests. -The requirements and tests in
Table II shall be inspected on a 100% basis. All examinations
and tests shall be conducted at the standard ambient
temperature (+60° to +90°F).
TABLE II - Classification of Defects
Output voltage and
4.4.3 Acceptance and rejection. -Rejected lots shall be
screened for all defective characteristics. Removal or
correction of defective units and resubmittance of rejected
lots shall be in accordance with "Acceptance and Rejection" as
specified in MIL-STD-105.
4.5 Special sampling
4.5.1 General. -One power supply shall be randomly selected
as a sample FROM 100 produced or from each month's pro-
diction, whichever comes first. The sample shall meet the
requirements and tests in Table III.