 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-22684/1B
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those listed in the issue of the Department of Defense Index of
Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-22684 - Resistors, Fixed, Film (Insulated), General Specification.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-202 - Test Methods for Electronic and Electrical Component Parts.
MIL-STD-1285 - Marking of Electrical and Electronic Parts.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available
from the Document Automation and Production Service, Building 4D (DPM-DoDSSP), 700 Robbins
Avenue, Philadelphia, PA 19111-5094.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related association specification, specification sheets, or MS
standards), the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 General. The requirements for acquiring the product described herein shall consist of this
document and MIL-PRF-22684.
3.2 Interface and physical dimensions. Resistors shall meet the interface and physical dimensions
specified on figure 1, as applicable.
3.3 Power rating. The power rating shall be 1/4 watt based on full load operation at an ambient
temperature of 70C.
3.4 Voltage rating. The maximum continuous working voltage shall not exceed 250 volts.
3.5 Resistance values and resistance tolerances. The minimum and maximum standard resistance
values and associated resistance tolerances shall be as listed in table I.
3.6 Terminal type. The terminal type available shall be in accordance with MIL-PRF-22684 and table I.
3.7 Dielectric withstanding voltage. Resistors shall be tested as specified in MIL-PRF-22684. The
magnitude of test voltage shall be as follows:
Atmospheric pressure - 500 volts rms.
Barometric pressure - 325 volts rms.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals