 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-23016(Wep)
3.1.8.1
(Continued)
(f) Limitation of amount of aeration reaching the dissimilar metal
faces, such as steel bolts in aluminum with all surfaces of
contact sealed with zinc-chromate primer, vinyl films, sealing
in dry gas or air, or equivalent.
(g) Any other systems of protection which are designed to alle-
viate electrolytic corrosion shall be subject to the approval
of the procuring activity.
3.1.9
Electrical Tape:
Fabric or textile, pressure-sensitive (adhesive or friction) tape
shall not be used, except as specified herein. Non-moisture-absor-
bing tape may be used for mechanical purposes or when included in
hermetically sealed assemblies.
Fasteners, Snap Slides. and Studs:
3.1.10
Fasteners, snap slides, and studs shall be designed to fasten easily
and hold firmly and positively the movable or separate part to its
mounting or other supporting structure under all service conditions.
The designs shall be such as to permit quick and easy fastening and
unfastening without requiring the use of any spatial tools. If snap
slides and studs are used, they shall conform to the requirements of
Standard AN3195, AN3196, AN3197, AN3198, AN3199, or AND10082.
Finishes:
3.1.11
Parts, including hardware item of the equipment not covered by
subsidiary specifications unless contained in hermetically sealed
units, shall be resistant to corrosion and there shall be no destruc-
tive corrosion, after subjection to a 48-hour salt spray test in
accordance with Federal Test Method Standard No. 151. Parts which
are lubricated in equipment may be tested in a lubricated condition.
Destructive corrosion shall be construed as being any type of corro-
sion which in any way interfere with mechanical or electrical per-
formance. Lusterless finishes shall be used in all surfaces visible
to operating personnel. Where cleaning operations on metal parts
are not specified in detail, they shall be in accordance with
commercial practices which will not cause subsequent destructive
corrosion. It is not the intent that parts procured to the speci-
fications listed in ANA Bulletin No. 400 must be refinished.
22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals