 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-23016(Wep)
(Continued)
3.2.9.4.4
Such surfaces shall be covered with removable protective coating
to prevent corrosion prior to assembly. This requirement shall
take precedence over any conflicting requirements in specifications
on finishes.
3.2.9.4.5
Component Placement:
Components shall be placed and circuitry arranged to obtain
minimum undesired coupling and to require a minimum number of
filter components.
3.2.9.4.6
Line Shielding:
It is preferred, that interference reduction be accomplished
inside the equipment when such means give results equal to or
better than the use of a shielded line. Any line shielding
used shall be prescribed as an installation requirement.
Under no condition shall line shielding be used for primary
3.2.9.4.6.1
power leads to equipment.
Equipment requiring antennas shall be designed to utilize
3.2.9.4.6.2
shielded coaxial cable as lead-in. When it has been determined
that a single braid shield is not adequate, a double or triple
braid or a solid shield shall be used as required.
3.2.9.4.7
Interference Control Components:
When additional interference control components are required
after careful design in accordance with the foregoing paragraphs,
components shall be used that conform to the environmental require-
ments for the equipment. Heretically sealed interference control
components shall be used even though the equipment is not her-
metically sealed. Separately installed and external components
shall not be used unless specifically authorized by the procuring
activity.
3.2.9.5
The contractor shall use the latest engineering design procedures
and techniques to assure that the equipment will comply with the
requirements of this specification.
54
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals