 |
|||
|
Page Title:
Test Samples Generating only Broadband Interference |
|
||
| ||||||||||
|
|  MIL-R-23016(Wep)
3.2.9.10.6.1 Test Samples Generating only Broadband Interference (not
intended to generate or receive: signals):
The following procedures shall be employed in testing for
broadband interference:
(a) Set up antenna in accordance with figure 9, 10, 11, or 12,
as applicable, opposite the center of the test sample,
but without a bond from the instrument to the ground
plane.
(b) Scan the full frequency range of the lowest tuning band
of the test instrument in use for the frequency of maxi-
mum interference or susceptibility.
(c) Move the antenna horizontally to the position of maximum
indication at that frequency, except that dipole antennas
of dimension longer than the test sample shall be placed
opposite its center.
(d) Bond instrument to ground plane when required and proceed
with measurement.
3.2.9.10.6.2 Test Samples Intended to Generate or Receive Signals:
The following procedures shall be employed in testing samples
intended to generate or receive signals:
(a) Set up antenna in accordance with figure 9, 10, 11, or 12,
as applicable, opposite the center of the test sample, but
without a bond from the instrument to the ground plane.
(b) Adjust sample for a mode of operation and control settings,
including frequency, which may be expected to result in a
maximum of interference or susceptibility.
(c) Scan the full frequency range of the test instrument in use
for a maximum indication of interference or susceptibility.
(d) Move the antenna horizontally to the position of maximum
indication of interference at that frequency.
68
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals