 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-24159A(SH)
A terminal strip with ground shall be provided and
3*3*4*3 Terminal strip.
mounted in the unit.
3.4 Shock. The receptacle assembly shall be capable of passing the high-
impact shock test specified in MIL-S-901 (see 4.6.2).
3.5 Welding. The surfaces of all parts to be welded shall be free from
rust, scale, paint, grease and other foreign matter. All welding shall be in
accordance with MIL-STD-278.
3.5.1 Where zinc-coated steel is used for fabricating parts, the metallic
zinc shall be removed from all joints and surfaces on which welds are to be
deposited and for a distance of 1/2-inch from the expected toes of the welds.
In areas where the metallic zinc cannot be removed and it is necessary to weld
over the zinc-coated surfaces, electrode type 6010 in accordance with QQ-E-450
shall be used.
3.6 Finish. Zinc coated surfaces including welds and areas damaged by
shearing, punching, bending, welding, or any other fabricated process, shall
receive a thorough wash and a hot phosphate acid treatment, or a pretreating
coating in accordance with DOD-P-15328, prior to applying one coat of primer
conforming to TT-P-664 or DOD-P-17545 and at least two final coats of gray
enamel.
3.7 Identification and information plates. Each receptacle assembly
shall be provided with an identification plate not to exceed 4 by 3 inches.
The type of markings for the letters shall be Gothic capitals, and numerals and
other characters shall be of similar appearance. The size of letters, numerals
and other characters shall be necessary for easy readability. The plate shall
be of the anodized aluminum photographic process type.
The identification plate shall contain the
3.7.1 Identification plate.
following information:
(a)
Item name.
Air capacity.
(b)
Current and voltage rating.
(c)
Federal stock number.
(d)
(e)
Component identification number (CID).
(f)
Contract number.
Manufacturer's name and address.
(g)
Weight.
(h)
3.7.2 Information plates. Information plates (operating instructions)
shall be provided as shown on figure1.
3.8 Drawings. Drawings shall be in accordance with the data ordering
document specified in the contract (see 6.2.2).
3.9 Workmanship. Sharp edges, burrs and other Imperfections shall be
removed from all parts subject to contact with personnel to prevent cuts during
repair and maintenance.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals