 |
|||
|
Page Title:
Resistor, Fixed, Wired Wound (Power Type) Styles RW80 and RW81 |
|
||
| ||||||||||
|
|  INCH-POUND
MIL-R-26/6C
14 June 2001
SUPERSEDING
MIL-R-26/5B
11 May 1973
MILITARY SPECIFICATION
RESISTOR, FIXED, WIRE WOUND (POWER TYPE),
STYLES RW80 and RW81
THIS SPECIFICATION IS INACTIVE FOR NEW DESIGN (SEE 6.4)
This specification is approved for use by all Depart-
ments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the associated requirements for styles RW80 and RW81 resistors.
1.2 Part or Identifying Number (PIN). Resistors covered by this specification are identified by a PIN,
which consists of the style designation, characteristic, and coded resistive value. The PIN is derived in
accordance with MIL-PRF-26 and is in the following form:
49R9
F
RW80
U
|
|
|
|
|
|
|
|
Style
Characteristic
Resistance
Resistance
(1.2.1.1)
(1.2.1.2)
(1.2.1.3)
tolerance
(1.2.1.4)
1.2.1.1 Style. The style is identified by the two-letter symbol "RW" followed by a two-digit number.
1.2.1.2 Characteristic. The characteristic is identified by a single letter that identifies the maximum
continuous operating temperature (surface hot spot), the minimum insulation resistance value at the end of
the moisture resistance test, and the resistance temperature characteristic in accordance with table I.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of
use in improving this document should be addressed to: Defense Supply Center, Columbus, ATTN:
DSCC-VAT, P.O. 3990, Columbus, Ohio, 43216-5000, by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
1 of 7
FSC 5905
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals