 |
|||
|
Page Title:
Application of quality assurance provisions |
|
||
| ||||||||||
|
|  MIL-R-45979
a n d accurate analyses; and this certificate is made
for the purpose of inducing payment and with knowledge
t h a t the information and certification may be used as
a basis for such payment."
e.
Signature and title of certifying official.
4 . 5 . 5 Application of quality assurance provisions. The inspection
p r o v i s i o n s specified should be applied at the earliest practical point in
m a n u f a c t u r e at which it is feasible to inspect for acceptance without risk
Reinspection
o f change in the characteristic by subsequent operations.
o f these characteristics on the completed product is not required provided
assurance exists that the characteristic has not been changed, degraded or
damaged by subsequent manufacturing, assembly or handling and that adequate
i n s p e c t i o n records are maintained.
In any event, the Government reserves
a l l rights under General Inspection Article 5, Standard Form 32.
The following methods
4 . 5 . 6 Q u a l i t y engineering inspection
methods.
a p p l y as applicable:
W h e r e "Visual" is specified as the inspection method for
a.
p r o t e c t i v e coating, the coating shall be visually examined
f o r completeness, uniformity in appearance and color, and
f o r freedom from pits, corrosion, scratches, and worn or
bare spots.
b.
W h e r e "Visual" is specified as the inspection method for
d i m e n s i o n a l inspection, the characteristic shall be either
scaled, or compared with a specimen of known acceptable
q u a l i t y that has been established as an inspection standard,
for conformance to the requirements of the drawing.
W h e r e "Visual" is specified as the inspection method for
c.
assemblies, the assembly shall be visually examined for
c o m p l e t e n e s s , security, function and conformance to
W h e n possible, the functioning
s p e c i f i e d requirements.
of the assembly shall be inspected by manual operation.
W h e r e "Visual" is specified as the inspection method for
d.
surface roughness values, a comparison standard conforming
t o ANSI B46.1 shall be used. If determination of surface
roughness by comparison standard is questionable, a surface
measuring instrument shall be used.
Where "SMTEt' (Standard Measuring and Test Equipment) is
e.
s p e c i f i e d as the method of inspection, the contractor may
u s e any type industry-developed, commercially available,
m u l t i - u s a g e equipment or special inspection and/or testing
( P r e v i o u s l y identi-
equipment approved by the Government,
f i e d as; "SME", Standard Measuring Equipment and "STE".
Standard Test Equipment.)
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals