 |
|||
|
Page Title:
Sampling for inspection and acceptance |
|
||
| ||||||||||
|
|  MIL-R-60346C
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection . Unless otherwise specified in the con-
tract or purchase order, the supplier is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise speci-
fied in the contract or order, the supplier may use his own or any other
facilities suitable for the performance of the inspection requirements speci-
fied herein, unless disapproved by the Government. The Government reserves
the right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
4.2 Sampling for inspection and acceptance . Sampling for inspection shall
be performed in accordance with the provisions set forth in MIL-STD-105 except
where otherwise indicated. For purposes of sampling, and in the absence of
more formal inspection lot definitions, the inspection lot for examination and
tests shall consist of all material of the same type, filament code, and class
submitted for delivery and one time.
4.2.1 Inspection of materials and components . In accordance with 4.1
above, the supplier is responsible for insuring that materials and components
used were manufactured, examined, and tested in accordance with the re-
quirements of this specification and, to the extent specified, of all
referenced subsidiary specifications and standards. In the event of conflict,
this specification will govern.
4.2.1.1 Supplier's certification . The supplier shall certify that (a) all
roving balls were produced under the same manufacturing process; (b) the glass
is "E", or "S", or general purpose high tensile strength "S" as specified (see
1.2 and 3.1.2); (c) the nominal filament diameter corresponds with code letter
designation applicable to the strand specified (see 2.1 and 3.1.3); (d) the
sizing on the glass is compatible with the type of resin specified; (e) that
all splices if used, were made in accordance with 3.4.1.
4.2.2
Inspection of material .
4.2.2.1 Examination of the roving balls . Examination of the roving balls
shall be made in accordance with the classification of defects, inspection
levels and AQLs, set forth below. The lot size, for purpose of determining
the sample size in accordance with MIL-STD-105, shall be expressed in units of
one roving ball for examination in 4.2.2.1.1, and in units of shipping
containers for examination in 4.2.2.1.2.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals