 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-63322A(AR)
3.3.3 Physical dimensions. The physical dimensions of the
resistor network package shall comply with all requirements in
detailed drawing. Inspection of the physical dimensions shall be in
accordance with MIL-STD-883, Method 2016.
3.4 Electrical characteristics.
3.4.1 Resistor network characteristics. When resistor networks
are subjected to the test or condition specified in Table I the
percent change in resistance in each resistor element shall not
exceed the value specified in Table I. The condition or test
requirement method shall be in accordance with MIL-R-83401 for
characteristic M resistor networks unless otherwise specified herein.
3.4.2 Maximum voltage. The maximum continuous working voltage
applied to the resistor elements shall be 20 volts d.c. or 20 volts
rms (root-mean-square, sine-wave).
3.5 Device marking.
3.5.1 Marking. Each resistor network shall be marked in
accordance with Method 1 of MIL-STD-1285 as follows:
a.
Part number - 9292966X (X = Reevision letter).
b.
Supplier's code symbol.
c. Manufacturer's date code, first two digits shall be the
last two digits of the number of the year. The third and fourth
digits shall indicate the calendar week of the year.
d.
Pin No. 1 identifier as
specified in DWG 9292966.
3.5.2 Resistance to solvents. The markings on resistor
networks shall be legible after being subjected to the resistance to
solvents test of MIL-STD-202, Method 215.
3.5.3 Data requirements. Data shall be recorded on a go/no-go
basis and retained for all test called out by this specification.
(See 6.4).
3.6 First article inspection. This specification contains
provisions for first article inspection. Requirements for the
submission of first article samples by the contractor shall be as
specified in the contract.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals