4.4.3 Testing. Testing is described in the First Article and
Quality Conformance Inspection Tables.
4.4.4 Inspection equipment. The inspection equipment
required to perform the examinations and tests prescribed herein
is described in the `Paragraph Reference/Inspection Method Column'
of the First Article and Quality Conformance tables. Test and
measuring equipment and inspection facilities of sufficient
accuracy, quality and quantity to permit performance of the
required inspection shall be established and maintained by the
contractor. The establishment and maintenance of a calibration
system to control the accuracy of the measuring and test equipment
shall be in accordance with MIL-STD-45662. The contractor shall
submit for approval inspection equipment designs in accordance
with the terms of the contract (see 6.3).
4.5 Methods of inspections. The methods of inspection and
testing are given by reference in the First Article and Quality
Conformance Tables and 4.5.1 herein.
4.5.1 Visual and mechanical examination. Resistor networks
shall be examined to verify that the materials, design, construc-
tion, markings, and workmanship are in accordance with the
applicable requirements (See 3.2, 3.3, 3.3.2, 3.3.4, 3.5, and 3.7).
5.1 Preservation and packaging. The resistor network shall be
packaged in accordance with level B of MIL-R-39032.
5.2 Packing. The resistor network shall be packed in accor-
dance with level B of MIL-R-39032.
5.3 Marking. The packed components shall be marked in
accordance with the commercial requirements of MIL-STD-1188.
5.4 Shipping. When resistor networks from more than one lot
are shipped together, each lot shall be kept separate, and the
divisions between lots clearly indicated to prevent mixing of lots
6.1 Intended use. The networks covered by this specification
are intended for single-use, non-repairable, military devices.