 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-81128
(WEP)
SPECIFICATION
Military
D e c a l , Elastomeric Pigmented
MIL-D-8634
F i l m , For use on Exterior Surfaces
Federal Supply Code for Manu-
H a n d b o o k H4-1, H4-2
facturers
REQUIREMENTS
3.
General
Requirements.
-Marking shall comply with the following
3.1
general
requirements.
3.1.1
L o c a t i o n . -The location of marking shall be as required by the
drawings. Marking by methods I and II shall not be placed nearer than 0.06
inches to any corner, fillet or sharp edge.
3.1.2
Sequence of Marking.
-Marking shall remain visible after the
a p p l i c a t i o n of final protective finish. Marking shall not mar or penetrate plating,
a n o d i z i n g , paint, or other protective coating. If a protective finish is broken,
suitable repairs approved by the procuring activity shall be made.
3.1.3
S i z e . -Unless otherwise specified, size of characters used for
marking shall be appropriate for the part. For rocket motor assemblies, size and
spacing of characters used for marking shall be as shown in Table I below:
TABLE I
MARKING
SIZE
FOR
ROCKET
MOTOR
ASSEMBLIES
Height of Lettering
N o m i n a l Case Diameter
Spacing Between Lines
Up to 10 inches
.25 in. {.18 in. )
. 2 5 in. (.18 in. )
10 inches and over
. 5 0 in. {.25 in. )
. 3 8 in. (.25 in. )
NOTE: Reduced size lettering (i.e., that shown in parentheses above) may be used for
subordinate information if necessary to conserve space. Subordinate information is
d e f i n e d as that appearing below the &tted line in 3.3.3.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals