 |
|||
|
|
|||
| ||||||||||
|
| MIL-R-81939B (AS)
Electric fuze arming unit, The construction and inspection of the electric fuze arming
3.7
unit shall be in accordance with MIL-C-81842.
Workmanship. The workmanship displayed in fabrication and assembly of the bomb
3.8
racks shall be such as to assure, within design limitations, the ability of the bomb racks to meet their
performance requirements under all applicable environmental conditions specified herein. Unauthorized
repair, welding, heavy burrs, or parts assembled by introduction of high stresses not prescribed in the
drawings, are typical signs of inferior workmanship and shall because for rejection. The standards of
workmanship exhibited in the approved first article sample, subject to any qualification stated in the
government's notice of approval, shall be determinative of the requirements of the contract relative to
workmanship.
QUALITY ASSURANCE PROVISlONS (see 6.4)
4.
Responsibility for inspection. Unless otherwise specified in the contract, the contractor
4.1
is responsible for the performance of all inspection requirements as specified herein. Except as otherwise
specified in the contract, the contractor may use his own or any other facilities suitable for the performance
of the inspection requirements specified herein, unless disapproved by the government. The government
reserves the right to perform any of the inspections set forth in the specification, where such inspections are
deemed necessary to assure that the supplies and services conform to prescribed requirements.
Classification of inspection. The inspection of the bomb racks shall be classified as
4.2
follows:
First article inspection (see 4.3)
a.
Quality conformance inspection (see 4.4)
b.
4.3
First article inspection. First article inspection shall consist of all of the inspections
listed in Table I. First article inspection report format shall be in accordance with MI L-STD-83 1 (see
6.3).
sampling for first article inspection. First article bomb rack samples shall consist of the
4.3.1
first two bomb racks manufactured on contract. The bomb racks shall be permanently labeled A and B for
ease of identification. Failure of the bomb racks to pass any of the first article inspections shall be cause
for rejection (see 6.3).
Quality conformance inspection. Quality conformance inspection shall consist of the
4.4
following inspections:
Individual Inspections (see 4.4.1)
a.
b.
Sampling Inspections (see 4.4.2)
Quality conformance inspection report format shall be in accordance with MIL-STD-831 (see 6.3).
Individual inspections. Individual inspections are those inspections conducted on each
4.4.1
bomb rack. Individual inspections for the bomb racks are shown in Table II, Group 1. Failure to pass any
of these inspections shall be cause for rejection of the bomb rack.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals