 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-83407B
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the
Document Automation and Production Service, Building 4D (DPM-DODSSP), 700 Robbins Avenue, Philadelphia, PA
19111-5094.)
2.3 Non-Government publications. The following document(s) form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue
of the DoDISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DoDISS
are the issues of the documents cited in the solicitation (see 6.2).
NATIONAL CONFERENCE OF STANDARDS LABORATORIES
NCSL-Z540.1
-
Calibration Laboratories and Measuring and Test Equipment - General
Requirements.
(Application for copies should be addressed to NCSL International, 1800 30th Street, Suite 305, Boulder, Colorado
80301-1026).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM G 21
-
Standard Practice for Determining Resistance of Synthetic Polymeric Materials to
Fungi.
(Application for copies should be addressed to ASTM International, PO Box C700, 100 Barr Harbor Drive, West
Conshohocken, PA 19428-2959.)
INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)
ISO 10012-1
-
Quality Assurance Requirements for Measuring Equipment - Part 1: Metrological
Confirmation System for Measuring Equipment.
(Application for copies should be addressed to American National Standards Institute (ANSI), 11 West 42nd
Street, New York, NY 10036.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein (except for associated detail specifications, specification sheets or MS standards), the text of this document
takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with
the applicable specification sheet. In the event of any conflict between the requirements of this specification and the
specification sheet, the latter shall govern.
3.2 First article. When specified (see 6.2), a sample of parts shall be subjected to first article inspection (see 6.3)
in accordance with 4.3.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals