2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those listed in the issue of the Department of Defense Index of
Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitat ion (see 6.2).
DEPARTMENT OF DEFENSE
- Resistors, Fixed, Wire Wound, (Accurate), General Specification for.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are
available from the Document Automation and Production Service, Building 4D, (DPM-DODSSP), 700
Robbins Avenue, Philadelphia, PA 19111-5094.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related associated specifications, specification sheets, or MS sheets),
the text of this document takes precedence. Nothing in this document, however, supersedes applicable
laws and regulations unless a specific exemption has been obtained.
3.1 General. The requirements for acquiring the product described herein shall consist of this
document and MIL -R-93.
3.2 Interface and physical dimensions . Resistors shall meet the interface and physical dimensions
specified on figure 1.
3.3 Resistance values and resistance tolerances . The maximum and minimum resistance values, and
resistance tolerance shall be as specified in table I.
TABLE I. Resistance values and resistance tolerance.
3.4 Power rating. Power rating shall be 0.33 watt.
3.5 Maximum voltage. Maximum voltage shall be 300 volts direct current or peak.