 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-1123E
3.7 Equipment manual.- The supplier shall furnish with each machine an
equipment manual. Manual contents and distribution shall be as specified
in the contract or order (see 6.2).
3.8 Identification plates.- Each machine shall bear an identification
plate conforming to the requirements of MIL-STD-130. The plate shall be
installed on and furnished as part of the machinery or equipment for which
it is intended.
3.9 Finish.- The equipment shall be finished in accordance with the
manufacturer's regular commercial practice. Finish shall not be blistered,
chipped, or peeled.
3.10 Detailed requirements.-
*
3.10.1 Type I, shoe finishing machine.- The finishing machine shall be
a dustless, single unit model, electric motor driven. Power shall be trans-
mitted from the electric motors to the attachments by means of V-belt drive.
All shafts shall be balanced and quiet running in self-aligning bearings.
The frame shall be of malleable iron or steel and so fastened and braced
to the leg that the assembled machine is rigid. The legs shall be of
malleable iron, cast iron, or steel with at least one 5/8 inch hole in
each foot for anchor bolts. A hood shall be provided above the finisher
shaft, the length of the machine. Each finishing machine shall be pro-
vided with a conveniently located rack to hold forepart cutters and the
burnishing irons.
3.10.1.1 Suction system.- A suction system shall be Incorporated in the
machine and shall have a capacity sufficient to carry off all dust and
leather particles produced during operation of the machine. The suction
blower shall be connected to an independent electric motor and shall be
provided with a separate "on" and "off" push button switch. The dust
collected by the suction system shall be exhausted into a conveniently
located receptacle which may be detached for emptying or be so constructed
as to be easily cleaned out.
*
3.10.1.2 Type I, size A.- In addition to requirements of 3.10.1 and
3.10.1.1, the machine with all attachments installed shall not exceed
7 1/2 feet in length. The attachments shall be as tabulated in Table I
and mounted from left to right in the order listed.
TABLE I -
Type I, size A shoe finishing machine
Required
Nomenclature
Item No.
1
Cutter, forepart.
1
Heel trimmer with shank sander and wire
2
1
brush attachment.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals