 |
|||
|
Page Title:
Table III - Defect Classification |
|
||
| ||||||||||
|
|  MIL-S-1398E(AR)
4.4.3 Testing.
.
4.4.3.1 Moisture content.
(See Table II) - Major Defect.
TABLE II
Material
Star charge composition (see 3.3.1)
Black powder (see 3.3.2)
Felt (see 3.3.4)
Paper (see 3.3.3)
Chipboard (see 3.3.3)
The contractor shall provide controls to insure that the
material comply with the requirements. For verification the
contractor shall select and test one sample of each material used in
each eight hours production. A composition sample shall not be
used. If the moisture content of a sample exceeds the requirement
and loading has not begun, the material represented by the sample
shall be rejected. If components have been loaded with material
containing excessive moisture, the remaining unloaded material and
loaded components shall be rejected. Test procedures shall be as
specified in 4.5.1. The sample of star charge composition shall be
selected prior to consolidating the star assemblies.
4.4.3.2 Transportation vibration. The signal assemblies shall
be observed and examined visually, without disassembly, for any
evidence of failure to comply with the requirements as classified in
Table III.
TABLE III - Defect Classification
Defect
Classification
Signal functions during test (see 3.4.1)
Critical
Signal not safe to transport following
test (see 3.4.2)
Critical
Signal damaged after test (see 3.4.3)
Major
Signal packing damaged (see 3.4.4)
Major
4.4.3.2.1 First three (3) lots. Beginning with the first lot
produced and continuing until three (3) consecutive lots have
complied with the acceptance criteria specified, two hundred and
forty (240) signal assemblies shall be selected from each lot for
test in accordance with the procedure specified in 4.5.2. The lot
shall be rejected if any defect classified in Table III occurs.
24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals