Click here to make tpub.com your Home Page

Page Title: Quality Assurance Provisions
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Parts list (parts population)
Up
Switching Equipment, Combat System, Command and Control, Fire Control, And Interior Communication General Specification
Next
Table VII. Qualification inspection.



img
MIL-S-17000N(SH)
specified in the contract.  Where an Engineering Change Proposal (ECP) is
authorized for use on a contract, all drawings affected shall be revised and
resubmitted for approval to the destinations specified in the contract or
order (see 6.2.2).  After drawings have been approved, no changes shall be
initiated by the contractor without resubmission of the revised drawing for
approval of the change.  Where drawings are revised for reasons other than
authorized modification (such as developments necessary to comply with the
intent of the contract, for proper and satisfactory completion of the contract,
contractor initiated design improvements or simplification for manufacturing
purposes), the letter forwarding the revised drawings shall cite the approved
ECP which covers the modification.
3.12.2.5.4 The file number, serial number, and date of acceptance letter
shall be entered in the revision column of the drawings.  The drawings shall
then be redistributed in accordance with the requirements of the contract.
3.12.2.5.5 The record of previous revisions on drawings shall be retained
when these drawings are revised for final delivery in the contract or order
(see 6.2.2).
3.13 Workmanship.
Workmanship shall be in accordance with requirement 9
of MIL-STD-454.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.  Unless otherwise specified in the con-
tract or purchase order, the contractor is responsible for the performance of
all inspection requirements as specified herein.  Except as otherwise specified
in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified
herein, unless disapproved by the Government.  The Government reserves the right
to perform any of the inspections set forth in the specification where such
inspections are deemed necessary to assure that the supplies and services conform
to prescribed requirements.
4.1.1 Quality program.  The contractor shall provide and maintain a
quality program acceptable to the Government for supplies and services covered
by this specification as specified in the contract or order (see 6.2.1).
The inspection requirements specified
4.2 Classification of inspection.
herein are classified as follows:
(a) Qualification inspection (see 4.3).
(b) Quality conformance inspection (see 4.4).
4.3 Qualification inspection.  Qualification inspection shall be con-
ducted at a laboratory satisfactory to NAVSEA. Qualification inspection
shall consist of the examination and tests shown in table VII.
54

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
9438 US Hwy 19N #311 Port Richey, FL 34668

Phone For Parts Inquiries: (727) 755-3260
Google +