 |
|||
|
Page Title:
Table IV. Examination Schedule. - Continued |
|
||
| ||||||||||
|
|  MIL-S-46777C
TABLE IV. Examination Schedule (continued).
First
Qual.
Requirement
Prod.
Conf.
Defect
paragraph
1
2
3
4
3.9, table III
X
X
116.
Upper fifth wheel and front supports not as
specified.
3.9, table III
X
117.
Suspension components not as specified,
X
incorrect alinement, or inadequate rating.
-
118.
Loading of any tire exceeding highway or
3.9, table III
X
ML rating.
119.
Brake system not as specified.
3.9, table III
X
X
120.
Electrical system not as specified.
3.9, table III
X
X
121.
Lubrication system not as specified.
3.12
X
X
122.
Servicing and adjustments incorrect,
3.13
X
X
incomplete, or not as specified.
123.
Workmanship not as specified.
3.15 thru 3.15.9
X
X
124.
Leaks in air or hydraulic lines.
section 3
X
X
125.
Seals do not prevent entrance of foreign
section 3
X
X
material or do not prevent leak age of fluid
or grease.
126.
Assembly incorrect or not complete.
section 3
X
X
127.
Parts or components missing or do not
section 3
X
X
function.
4.5.1.1 Stress calculations. Stress calculations (see 3.1.3) for the load-carrying members of
the semitrailer shall be made. The theoretical load for the stress calculations shall weight
3,000 pounds per cubic yard for aggregate and 425 pounds per cubic yard for refuse, as
applicable, for a truck. The minimum payload shall be that specified in table I and the applicable
specification sheet. Stress in any load-carrying member in excess of 33 percent of the yield point
of the material shall constitute failure. Stress calculations for the upper fifth wheel plate
assembly shall be as specified in 3.9, table III.
4.5.2 Tests. Tests shall be in accordance with table V and as specified herein. The
contractor may use any truck-tractor for tests in 4.5.2.2 through 4.5.2.4 and 4.5.2.6, with the
provision that the contractor's selected truck-tractor model has a published GCWR by its
manufacturer equal to or in excess of the actual GCWR of the maximum test weight of the
combination and conforms to the safety, performance, and dimensional compatibility
requirements specified herein.
41
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals