 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-46874 (MI)
Table II. Tolerances
Dimension
Tolerance (Inch)
(Inch)
Rubber
Metal
.06 through .125
+.03, - .015
+.015, -0
.03
Over
.125 through .19
+.015, -0
.03
Over
.19 through .375
+.03, -0
.06
Over
.375 through .50
+.05, -0
.06
Over
.50 through .75
--
3.7 Product identification.
3.7.1 Information to be shown. Unless otherwise specified in a procuring
document, each separate sheet and strip of material shall have a tag attached showing
the following:
a.
MIL-S-46874 and appropriate dash number.
b.
Vendor's name and code.
c.
Manufacturer's material designation
d.
Date of manufacture (year and quarter).
3.7.2 Marking. Marking shall be in accordance with the requirements of
MIL-STD-129.
3.8 Workmanship. The material shall be of high quality and uniformity and
shall be free of contamination, unevenness, tears, cuts, abnormal holes, and other
defects. Workmanship shall be such as to ensure a product which is in conformance
with this specification.
4.
QUALITY ASSURANCE PROVISIONS
4.1
Responsibility for inspection. Unless otherwise specified in the contract
or purchase order, the supplier is responsible for the performance of all inspection
requirements as specified herein. Except as otherwise specified in the contract or
order, the supplier may use his own or any other facilities suitable for the performance
of the inspection requirements specified herein, unless disapproved by the
Government. The Government reserves the right to perform any of the inspections set
forth in the specification where such inspections are deemed necessary to assure
supplies and service conform to prescribed requirements.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals