 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-2211E
3.3.1.1 Reinforcing and edging. The top shall be reinforced with
steel angles specified in 3.2.2.2 and securely held to plywood top with
wood screws. All edges of top shall be protected with aluminum angles
specified in 3.2.2.1, and securely held to plywood top with wood screws.
3.3.2 Battens. The battens shall be plywood specified in 3.2.1 and
with all sides and edges sanded smooth. Battens shall be fastened to
plywood top with adhesive specified in 3.2.6 and securely held in place
with wood screws.
3.3.3 Hinges. Angles and channels forming hinges shall be firmly
bolted through the battens and the top with 3/8-inch carriage bolts,
countersunk Into the top and the nuts tightly drawn against lockwashers.
*
3*3.4 Legs end braces. The legs, stretchers and braces shall be formed
from the steel sheet or strip specified in 3.2.2.2.
Finish.
3.3.5
3.3.5.1 Plywood. All exposed surfaces of plywood parts shall be
cleaned of all dust and dirt. Exposed plywood shall be coated with spar
varnish as specified in 3.2.5, before assembly and with a sufficient
number of coats to produce a uniformly glossy appearance.
3.3.5.2 Metal. All metal surfaces, except aluminum angles and the
heads of carriage bolts , shall be prepared for painting according to
type I or II of TT-C-490, and shall be coated with enamel specified in
3.2.4.
3.4 Marking for identification. Marking for identification of the
tables shall be on the underside of the top and shall be in accordance
with the requirements of MIL-STD-130.
3.5 Workmanship. Tables shall be free from defects such as fractures,
splits, punctures, or dents. There shall be no sharp edges, slivers,
burrs, or projections.
3.5.1 Application of finish, The finish applied to the end item shall
be continuous, smooth, adherent without discoloration or foreign material
imbedded end contains no sags, rum, drips, creeps, laps, bubbles, streaks,
wrinkles, blitsters, cracks, scratches, pores, pits, lumps, flux, or orange
peel. No rust, rough grinds or toolmarks shall show through the coating.
3.5.2 Welding. All surfaces of parts to be welded shall be clean.
Welding shall be l ccomplished in a manner which will prevent the occur-
rence of burn holes, cracks, fractures or incomplete fusion. All scale and
flux deposits shall be removed from finished welds.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals