Click here to make tpub.com your Home Page

Page Title: Heater and defroster
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-45380E(AT)
space of these tools may be furnished inside the cab. When stowage space for the tools is
located outside of the cab, it shall be waterproof and shall provide for locking with a padlock.
3.4.16.1 Too1s. When specified (see 6.2), the vehicle shall be furnished with tools
required for exchanging a mounted tire assembly with the spare assembly and shall include at
least a jack, jack handle, and wheel nut wrench. The jack shall be of such closed height as to
permit its location under axle or other satisfactory lift point at any wheel with the tire flat. The
jack without blocking, shall be capable of raising any wheel of the loaded vehicle to a height
adequate to permit removal and replacement of a wheel and tire assembly.
3.4.17 Heater and defroster. A hot water heater shall be provided. The heater shall have
fresh air intakes. Discharge outlets shall be provided to direct heated air to floor and to defroster
louvers. The heater shall be complete with blower and mounted controls convenient to the
driver.
3.4.18 Controls and operating mechanisms. All controls and operating mechanisms shall
be located for left-hand drive. Controls shall be complete and conveniently operable by the
driver. Lever controls shall be designed and located to permit easy entrance and exit of the
operator to and from the driver's compartment. Instruments and controls shall be identified as to
their function and installed in a manner to facilitate removal and servicing. Instruments shall be
panel mounted and visible to the driver when seated in driving position.
*
3.4.19 Accessories and equipment. Chassis equipment shall be complete with all
accessories furnished as standard equipment by the manufacturer. The following minimum
equipment shall be furnished:
(a)
Key-operated ignition switch
(b)
Ammeter, charging indicator or voltmeter
(c)
Fuel gage
(d)
Oil pressure gage or red indicator warning light
(e)
Engine coolant temperature gage or high coolant temperature or low coolant level
red indicator warning light
(f)
High coolant temperature or low coolant level alarm buzzer
(g)
Speedometer with recording odometer
(h)
Ash receptacle
(i)
Dual sunvisors
(j)
Front door mounted armrest on driver's side on model 4x2 and 4x4
(k)
Driver's compartment ventilator other than window
(l)
Tachometer (for diesel engine driven vehicles).
19

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business