 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-45382A
prior to completion of said tests, unless
in AQL's. This deficiency may be deleted from
satisfactory evidence to the contrary is furnished
the minor classification of characteristics when
to the contracting officer. The deficiencies shall
five consecutive lots are found free of the
be corrected by the contractor at his own cost,
deficiency.
including the cost of labor.
4.5 Tests.
4.4 Inspection provisions.
4.5.1 Performance. Vehicle shall be subjected
4.4.1 Lot formation. A lot shall consist of all
to road and performance tests specified in
vehicles of one type from an identifiable
table VII. Vehicle shall be serviced with specified
production period, submitted at one time for
products listed in table I of paragraph 3.5. Vehicle
inspection.
tests shall be conducted at locations shown in
table VII.
4.4.2 Sampling. For the purpose of visual,
dimensional, and primary functional examination,
4.5.2 Five-mile road test. Each vehicle selected
a representative sample shall be selected from
in accordance with 4.4.2 shall be operated for a
each lot in accordance with inspection level II of
distance of not less than five miles by the
Standard MIL-STD-105.
contractor. Vehicles shall be completely
4.4.2.1 Examination. The representative sample
assembled and serviced. Test course or area shall
be selected by the manufacturer in the vicinity of
vehicles, selected in accordance with 4.4.2, shall
the manufacturing facility; and shall be on smooth,
be examined to verify compliance with this
approximately level, hard-surfaced roads.
specification using the following classification of
Vehicles (less payload) shall satisfactorily pass the
defects and acceptable quality levels (AQL's)
performance requirements specified in 3.5.1.1
listed in tables V and VI.
(highway towing speeds), 3.5.3 (turning ability),
4.4.2.1.1 Unclassified characteristics. All
and 3.5.4 (braking ability).
defects having no bearing on function, safety,
4.5.2.1 Fording test. To determine
interchangeability or life, but are considered
departures from good workmanship will be noted
conformance to 3.5.7, vehicle shall be towed
in writing. Workmanship deficiencies falling
through water of depth to submerge the vehicle
within this category and recurring in five
running gear for 15 minutes duration. On
consecutive lots or 10 lots or more within a 30-day
completion of fording requirements examination
period will be added to the minor classification of
of vehicle and components shall be made for
characteristics of the specification with no increase
damage and lubrication contamination.
Table V. Major Defects AQL=25 Defects/100 Units
Method of
Categories
Characteristics
Defects
Inspection
Major:
Frame and bed . . . . . . . . . . . .
101
Structural, welding riveting or sheet metal defects
Visual
Front undercarriage . . . . . . . .
Malfunction; damage; welding defects . . . . . .
102
Visual and
functional
Axles . . . . . . . . . . . . . . . . . . . .
103
Improper assembly or installation; welding defects
Visual and
functional
104
Service brakes, automatic
Malfunction; chatter and squeal; components
Visual and
actuation, and parking brakes.
damage; air and hydraulic leaks; nonconformance
functional
to holding.
105
Electrical system components and
Malfunction; inoperative; lighting sequence
Visual and
circuits.
improper; damage.
functional
106
Suspension system components,
Damage; malfunction; hydraulic leaks;
Visual and
and spring compression
nonconformance.
functional
cylinders
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals