 |
|||
|
Page Title:
First article (initial production)submission |
|
||
| ||||||||||
|
|  MIL-T-46386A(MU)
specified, the supplier may utilize his own facilities or any commercial
laboratory acceptable to the Government. The Government reserves the
right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the Quality Assurance Provisions
of this specificaiton. Definitions of inspection terms shall be as listed
in MIL-STD-109.
4.2 First article (initial production)submission. - When required by
the contract, an initial production sample shall be submitted to a Government
approved facility for test and evaluation in accordance with the contract
schedule. The sample shall consist of three telescopes. The sample shall
be manufactured in the same manner, using the same materials, equipment,
processes and procedures as used in regular production. All parts and
materials, including packaging and packing, shall be the same-as used for
regular production and shall be obtained from the same source of supply.
After inspection and provisional acceptance at source, the initial production
sample shall be inspected at a Government approved facility for all
requirements of the drawings, and specifications. The Government reserves
the right to require new initial production samples until such time as an
acceptable sample is submitted.
4.3 Inspection
provisions.
4.3.1 Submission of product. - Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and presentation
of lots shall be in accordance with "Submission of Product" provisions of
MIL-STD-105.
4.3.2 Examination and tests.
4.3.2.1 components and subassemblies. - All components and subassemblies
shall be inspected in accordance with the inspection provisions contained.
in Supplementary Quality Assurance Provisions (SQAP) listed in the List of
Inspection Documents (IEL), when provided with the technical data package
(TDP). In the absence of SQAP'S the applicable Quality Assurance Provisions
of MIL-F-13926 shall apply.
4.3.2.2 Final acceptance inspection. - Subsequent ot first article
approval, examination and tests related to Section 3 herein shall be
performed on a single defect (individual characteristic) basis in accordance
with MIL-sTD-105 and the sampling plans specified in Table I herein.
Examination and tests for Packaging, Packing and Marking shall be in
accordance with MIL-P-14232 and Section 5 herein. The tabulated class-
ification of defects in Table I shall constitute the minimum inspection
to be performed by the supplier after first article approval and prior
to Government acceptance or rejection by item or lot.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals