Click here to make tpub.com your Home Page

Page Title: Quality conformance inspection
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




MIL-T-46590C
4.5 Quality conformance inspection.
4.5.1 Lot.
4.5.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation and
identification of lots shall be in accordance with MIL-STD-105.
4.5.1.2 Size of lot. The production lot size shall be as specified in the contract.
4.5.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed on a defect basis in accordance with the
classification of defects. Four power (4x) magnification may be used in performing visual examination for
such defects as burr and foreign matter. Inspection for rubber O-rings shall be in accordance with MIL-STD-
413. When compliance with the applicable requirement is in doubt as a result of visual examination, the
characteristic shall be measured or gaged to determine acceptability. All nonconforming material shall be
rejected.
4.5.2.1 Pin, Shear, Drawing 8593876, covering a detail of Drawing 10520876.
Characteristics
Defect
Method of Inspection
Critical
None defined
Major
101
Diameter, max
Gage
102
Total length, min
Gage
103
Metal defective
Visual
104
Protective finish inadequate or defective
Visual
105
Burr
Visual
106
Foreign matter
Visual
Minor
201
Total length, max
Gage
202
Profile of ends
Visual
203
Surface finish improper
Visual
4.5.2.2 Pin, Firing, Drawing 8593878, covering a detail of Drawing 10520876.
Critical
None defined
6

Privacy Statement - Press Release - Copyright Information. - Contact Us