Click here to make tpub.com your Home Page

Page Title: Quality assurance terms and definitions
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Bypass pressure
Up
Thruster, Cartridge Actuated, M13 Assembly
Next
Assembly, Drawing 10520971



MIL-T-46604B
quality program. The absence of any inspection requirements in the specification shall not relieve the
contractor of the responsibility of ensuring that all products or supplies submitted to the Government for
acceptance comply with all requirements of the contract. Sampling inspection, as part of manufacturing
operations, is an acceptable practice to ascertain conformance to requirements; however, this does not
authorize submission of known defective material, either indicated or actual, nor does it commit the
Government to acceptance of defective material.
4.1.2 Quality assurance terms and definitions. Reference shall be made to MIL-STD-109 to define the
quality assurance terms used.
4.1.3 Inspections. Inspections shall be in accordance with MIL-A-2550 and MIL-STD-453.
4.2 Inspection provisions.
4.2.1 Lot.
4.2.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation, and
identification of lots shall be in accordance with MIL-STD-105.
4.2.1.2 Size of lot. The production lot size shall be as specified in the contract (see 6.2).
4.2.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed in accordance with the classification of defects.
Four power (4x) magnification may be used for inspection of such defects as burr and foreign matter. When
compliance with the applicable requirement is in doubt as a result of visual examination, the characteristic
shall be measured or gaged to determine acceptability. All nonconforming material shall be rejected.
4.2.2.1 Cartridge, Drawing 8595513, covering a detail of Drawing 10520971.
Characteristics
Defect
Method of Inspection
Critical
1
Mixed cartridges
Visual
2
Metal defective
Visual
3
Marking missing, incorrect, or illegible
Visual
Major
101
Foreign matter present
Visual
Minor
201
Case scratched, wrinkled, bulged, or dented
Visual
202
Varnish missing or inadequate
Visual
4.2.2.2 Assembly, Drawing 10520971, less Protective Plug, MIL-C-5501, and Drawing 10520975
5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
9438 US Hwy 19N #311 Port Richey, FL 34668

Phone For Parts Inquiries: (727) 755-3260
Google +