 |
|||
|
Page Title:
Cartridge, Drawing 8593275, covering a detail of Drawing 8593873 |
|
||
| ||||||||||
|
| MIL-T-46626C(OS)
4.1.3 Inspections. Inspections shall be in accordance with MIL-A-2550 and MIL-STD-453.
4.2 Inspection provisions.
4.2.1 Lot.
4.2.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation, and
identification of lots shall be in accordance with MIL-STD-105.
4.2.1.2 Size of lot. The production lot size shall be as specified in the contract (see 6.2).
4.2.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed in accordance with the classification of defects.
Four power (4x) magnification may be used for inspection of such defects as burr and foreign matter. When
compliance with the applicable requirement is in doubt as a result of visual examination, the characteristic
shall be measured or gaged to determine acceptability. All nonconforming material shall be rejected.
4.2.2.1 Cartridge, Drawing 8593275, covering a detail of Drawing 8593873.
Characteristics
Defect
Method of Inspection
Critical
1
Mixed cartridges
Visual
2
Metal defective
Visual
3
Marking missing, incorrect, or illegible
Visual
Major
101
Foreign matter present
Visual
Minor
201
Case scratched or dented
Visual
4.2.2.2 Assembly, Drawing 8593873, all components except Drawings 8593876, 8593878, 8593882,
and MS28775-012.
Critical
None defined
Major
101
Cartridge not flush with or below body end
Manual/Visual
102
Any part missing
Visual
103
Thread damaged or not full
Visual
104
Metal defective
Visual
105
Protective finish inadequate or defective
Visual
106
Burr
Visual
107
Foreign matter
Visual
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals