 |
|||
|
Page Title:
First Article Inspection Provisions |
|
||
| ||||||||||
|
| MIL-T-48236 (MU)
or portion thereof, as directed by the Contracting Officer, shall
also be submitted whenever there is a lapse in production for a
period in excess of 90 days or whenever a change occurs in man-
ufacturing process, material used, drawing or specification such
as to significantly affect product uniformity as determined by
the Government.
4.2.2 First article inspection provisions.
4.2.2.1 Component parts and subassemblies.-Twenty five (25)
complete sets of parts (i.e. 25 each of every component parts and
subassembly, including at least three (3) Items from each cavity
used to produce plastic parts and so identified as to permit
tracing each item to the cavity in which it was molded).
4.2.2.1.1 Inspections to
be performed.-The parts and sub-
the Government to any or all of
assemblies will be subjected by
the applicable examinations and
tests specified in 4.3.2, 4.3.3
and 4.3.5 of this specification
and any or all of the requirements
of the applicable drawings.
4.2.2.1.2 Inspections to
be performed .-The parts and sub-
assemblies will be subjected by
the Government to any or all of
the applicable examinations and
tests specified in 4.3.2, 4.3.3
and 4.3.5 of this specification
and any or all of the requirements
of the applicable drawings.
4.2.2.1.3 Rejection.-If any component or subassembly fails
to comply with any of the applicable requirements, the first
article sample shall be rejected. The Government reserves the
right to terminate its inspection upon any failure of a component
or subassembly to comply with any of the stated requirements.
4.2.2.2 Test set assemblies.-Thirty (30) test sets completely
packaged and sealed as required by the applicable drawings.
4.2.2.2.1 Inspections to be performed.-The thirty (30)
test sets shall be subjected to the following tests in the
sequence indicated in addition to the inspections specified In
4.3.2.9:
Functioning (see 3.5) in accordance with 4.4.2.
a.
b.
Five foot drop test (see 3.3) in accordance with 4.4.3.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals