 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-48409A(MU)
4.3.2.1 Components and subassemblies. - All components and subassem-
blies shall be inspected in accordance with the inspection provisions con-
tained in Supplementary Quality Assurance Provisions (SQAP'S) listed in
the Technical Data Package (TDP). In the absence of SQAP'S, the applic-
able Quality Assurance Provisions of MIL-F-13926 shall apply. Examination
and tests related to Section 3 herein, shall be performed on a single de-
fect (individual characteristic) basis in accordance with MIL-STD-105 and
the sampling plans specified in Tables I, II, and III herein. Examination
and tests for packaging, packing, and marking shall be in accordance with
MIL-P-14232 and Section 5 herein. The tabulated classification of defects
in Tables I, II, and III shall constitute the minimum inspection to be per-
formed by the supplier after first article approval and prior to Government
acceptance or rejection by item or lot.
TABLE I - CLASSIFICATION OF DEFECTS
(100% INSPECTION)
TEST PROCEDURE
REQUIREMENT
CHARACTERISTIC
No.
4.6.1
3.3.1
101.
Interchangeability
4.6.3
3.3.3
Performance - operation
102.
NOTE: The tests in Table I shall be conducted at a temperature
between +70F and +80F.
4.3.3 Acceptance and rejection. - Rejection lots shall be screened
for all defective characteristics. Removal or correction of defective
units and resubmittance of rejected lots shall be in accordance with
"Acceptance and Rejection" as specified in MIL-STD-105.
4.3.4 Certification. - Certification shall include test data and re-
sults for the characteristics specified below. Certificaiton shall be
provided prior to performing final acceptance inspection, and remain in
effect throughout the contract for Government acceptance. This does not
relieve the contractor from inspection throughout the contract productions
including recording data and results therefrom. Recorded data and results
shall be made available to the Government upon request. A new certifica-
tion will be required should any changes occur in materials, manufactur-
ing processes and techniques previously certified.
TEST DATA TO COMPLY WITH
NO.
CHARACTERISTIC
MIL-P-46843
301.
Cleaning
"
Drying
302.
"
Coating, insulating compound
303.
4.4 Special sampling.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals