 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-48460B(AR)
4.5 Quality conformance inspection.
4. 5.1 Procurement conditions. The following inspection plans shall apply
where the assembly is procured for use as a:
Plan
Use
A and C
a. Logistics spare assembly apart
from the next higher assembly
B and C
b. Component assembly of the next
higher assembly
4.5.2 Inspection plan A.
4.5.2.1 General sample and tests. One assembly, as a control sample,
shall be selected at random by the Government representative from each 100
assemblies produced and shall be subjected to all the tests in table IV.
4.5.2.2 Environmental sample and tests. Three assemblies, as a control
sample, shall be selected at random by the Government representative from each
50 assemblies produced or from each month's production, whichever occurs
first. All the tests in table V shall be applied separately to each assembly
in the sample.
4.5.2.3 Acceptance. Where any one assembly of either sample fails to
meet any specified requirements the lot shall be rejected. Rejected lots
shall be subject to the provisions of MI.L-STD-105.
4.5.3 Inspection plan B.
4.5.3.1 Sample and tests. The sample shall be selected by the Government
representative in accordance with the provisions of MIL-STD-105. All the
tests in table IV and only the test of item 307 in table V shall be applied.
4.5.3.2 Acceptance. Acceptance and rejection shall be in accordance with
MIL-STD-105.
4.5.4 Inspection plan C.
4.5.4.1 Sample and tests. Each assembly in every lot shall be subjected
to all the tests in table 111 and shall be examined visually for completeness,
improper assembly and evidence of poor workmanship.
4.5.4.2 Acceptance. Where any one assembly fails to meet any specified
requirement, the defective assembly shall be removed from the lot and
resubmitted only after all defects have been corrected.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals