 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-48466B(AR)
supplies submitted to the Government for acceptance comply with
all requirements of the contract.
Sampling inspection, as part of
manufacturing operations, is an acceptable practice to ascertain
conformance to requirements, however, this does not authorize
submission of known defective material, either indicated or
actual, nor does it commit the Government to accept defective
material.
4.1.2
Inspection equipment. Unless otherwise specified in
the contract, the contractor shall supply, maintain and calibrate
inspection equipment in accordance with the provisions of
MIL-I-45607 and MIL-STD-45662.
Contractor inspection equipment
designs shall be submitted for Government approval as specified
in the contract (see 6.5).
4.2 Classification of inspections. The inspection
requirements specified herein are classified as follows:
First article inspection (see 4.4)
a.
b.
Quality conformance inspection (see 4.5 and 6.8)
4.3 Inspection conditions.
Unless otherwise specified, all
inspections shall be performed in accordance with the quality
assurance provisions of MIL-F-13926 and the conditions of 3.3.1.
4.4 First article inspection.
The requirement for first
article approval and the designation of responsibility for first
article inspection to either the Government or the contractor
shall be specified in the contract (see 6.3).
4.4.1 Sample. The contractor shall submit a first article
sample as designated by the Contracting Officer for evaluation in
accordance with the provisions of 4.4.2.
The first article sample
shall consist of two assemblies.
4.4.2
Inspection.
Two assembles shall be subjected to all
the inspections specified in Tables I, II and III.
The examination
control tests shall be performed first.
4.4.3 Failure.
Failure of any assembly to meet any
requirement shall be cause for refusal to grant first article
approval.
The Government reserves the right to terminate first
article inspection upon any failure of any assembly to comply with
any stated requirement.
4.4.4 Responsibility.
The contractor, whether or not
responsible, shall inspect the sample for conformance to all
contractual requirements and shall submit a record of this
inspection with the sample and certificates of conformance for
materials.
The Government reserves the right to witness
inspections performed by the contractor.
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals