Prospective bidders should be made aware that a Nuclear
Regulartory License is required for the manufacture of this item.
6.3.1 Submission of designs for approval. Contractor
designs for final acceptance inspection shall be approved by the
Government prior to fabrication or procuring the equipment. The
contractor is referred to MIL-HDBK-204 for guidance. Submission
of design concept on inspection equipment is permissible for
tentative approval. The completion date for design review will be
based on the data of the final submission of designs and the
required delivery schedule as stipulated in the contract. Submit
designs as required to: Commander, U.S. Army Armament Research,
Development and Engineering Center, ATTN: AMXMC-QAF-I (D),
Picatinny Arsenal, NJ 07806-5000. This address will be speciied
on the Contract Data Requirements List DD Form 1423 in the
contract. Unless otherwise specified, data item DI-R-1714 will
apply. When the contractor submits inspection equipment designs
to the Government for approval, he shall give the following
information in his letter of transmittal:
The contract number.
The contract item (name, model number, etc.).
The designs remaining to be submitted and the expected
date of submittal.
6.4 Drawings. Drawings listed in Section 2 of this
specification under the heading US Army Armament, Research
Development and Engineering Center (ARDEC) may also include
drawings prepared by, and identified as Edgewood Arsenal,
Frankford Arsenal, Rock Island Arsenal, or Picatinny Arsenal
drawings. Technical data originally prepared by these activities
is now under the cognizance of ARDEC.
6.5 Subject term (key word) listing.
6.6 Changes from previous issue. Asterisks are not used in
this revision to identify changes with respect to the previous
issue due to the extensiveness of the changes.
(Project No. 1240-A953)