 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-52953C
3.18
Seat.
The seat shall conform to the requirements of SAE J 899.
3.19 Battery. The truck shall be furnished with battery(s) having a
capacity of not less than that specified on the applicable specification
sheet. Unless otherwise specified (see 6.2), batteries will be shipped wet
and charged.
3.19.1 Battery component . The battery compartment shall be provided with
a pictorial diagram showing battery connections which are visible when the
compartment is open for maintenance. The batteries shall be secured inside
the compartment to prevent unnecessary movement. The batteries shall be
sufficiently insulated to prevent accidental high current short and shall be
readily accessible for servicing. The compartment shall have holes in the
bottom to allow for drainage of excess fluids.
3.19.2 Batter connector . Unless otherwise specified (see 6.2), the truck
shall be equipped with SB type connectors.
3.19.3 Battery warning . A warning sign shall be affixed to the exterior
of the battery compartment that states the hazards present with the use of
batteries.
3.20
Human factors engineering .
3.20.1 Controls and instrumentation .
All controls and instrumentation
shall be provided with position markings conforming to ASME/ANSI B 56.11.3 and
labeled in accordance with SAE J 1362. The controls shall be operable and the
instruments shall be viewable by the 5th to the 95th percentile male and
female, according to the dimensions in SAE J 833a and shall be in accordance
with SAE J 297 and SAE J 898. Instrumentation shall be in accordance with SAE
J 209.
3.20.1.1 Discharge indicator . A battery discharge indicator containing a
lift interrupt shall be provided.
3.20.1.2 On-off switch. A key-operated on-off switch shall be furnished.
It shall have not less than two positions. The on and off positions shall be
labeled "ON" and "OFF" respectively. Two keys shall be furnished with each
truck. All keys shall be made to fit each and every truck.
3.20.1.3 Hour meter. An electrically operated hour meter shall be
provided, which registers up to 9999 hours in 0 .1 hour increments. The hour
meter shall be accessible for reading without removing any component of the
truck.
3.20.2 Human factors. The forklift shall be operable and maintainable by
the full range of user personnel (5th percentile female through 95th
percentile male) in accordance with, but not necessarily limited to, the
requirements of SAE J209, J297, J298, J833, J898, or ASM/ANSI B 56.11.3.
3.20.3 Nuclear-biological-chemical (NBC) protection . When specified (see
6.2), the forklift shall be operable and maintainable by the full range of the
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals