 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-53019(ME)
4.4.11 Productivity. The forklift shall perform the following operation.
The course shall be set up in accordance with figure 1. With the forks in the
front carry position travel to area "X". Pivot the forks to the side carry
position and retrieve load "A". Lower the load and travel to area "Y". Pivot
the load to the front and deposit it on the platform. Return to area "X" and
retrieve load "B" using the same sequence of operation. Return to area "Y" and
deposit load "B" on top of load "A". Return to area "X" and retrieve load "C"
using the same sequence of operation. Return to area "Y" and place load "C"
beside load "A". Back out and lower the forks to the floor. Raise the forks
and retrieve load "C" and return it to area "X". Deposit the load and return
to area "Y". Retrieve load "B" and deposit it on top of load "C" at area "X".
Return to area "Y" and retrieve load "A". Deposit the load on top of load "B"
at area "X". This constitutes one cycle of the test. The forklift shall
perform 30 cycles continuously using only one battery. The battery shall not
be charged during the test. The forklift shall only be allowed to stop to
change operators. Upon completion of the test travel speed and lift speed
with rated load shall be checked. Nonconformance to the requirements of
3.21.11 shall be cause for rejection.
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals