3.8.2 Burr. No part shall have a burr which might interfere with the assembly or function of
the item or which might be injurious to personnel handling the item.
3.8.3 Foreign matter. No part or assembly shall contain chips, dirt, grease, rust, corrosion,
or other foreign matter.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase
order, the contractor is responsible for the performance of all inspection requirements
(examinations and tests) as specified herein. Except as otherwise specified in the contract or
purchase order, the contractor may use his own or any other facilities suitable for the
performance of the inspection requirements specified herein, unless disapproved by the
Government. The Government reserves the right to perform any of the inspections set forth in this
specification where such inspections are deemed necessary to ensure supplies and services conform
to prescribed requirements (see 6.2).
4.1.1 Responsibility for compliance. All items shall meet all requirements of sections 3 and
5. The inspection set forth in this specification shall become a part of the contractor's overall
inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of ensuring that all products
or supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling inspection, as part of manufacturing operations, is an acceptable practice
to ascertain conformance to requirements; however, this does not authorize submission of known
defective material,either indicated or actual, nor does it commit the Government to acceptance
of defective material.
4.1.2 Quality assurance terms and definitions. Reference shall be made to MIL-STD-109 to
define the quality assurance terms used.
4.1.3 Inspections. Inspections shall be in accordance with MIL-A-2550 and MIL-STD-453.
4.2 Inspection provisions.
184.108.40.206 Submission of product. Unless otherwise specified by the contracting activity,
formation, and identification of lots shall be in accordance with MIL-STD-105.
220.127.116.11 Size of lot. The production lot size shall be as specified in the contract (see 6.2).