 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62110G
(h) Complete installation drawings are available to the procuring activity.
3.2 General design.
3.2.1 Federal Motor Vehicle Safety Standards. The vehicle and furnished accessories
shall comply with all Federal Motor Vehicle Safety Standards in effect on the date of
manufacture.
3.2.2 Air pollution control. The vehicle shall comply with the EPA Regulations
governing Control of Air Pollution from New Motor Vehicles and New Motor Vehicle Engines
in effect on the date of manufacture. In addition, vehicles destined for California shall comply
with the State of California regulations governing air pollution control in effect on the date of
manufacture.
*
3.2.3 Sound level. The interior sound level shall not exceed 84db(A). The vehicle
exterior drive-by sound level shall conform to EPA Noise Emission Standards for Transportation
Equipment - Medium and Heavy Trucks.
3.2.4 Safety. The vehicle and rotating derrick shall comply with ANSI A92.2 and all
OSHA requirements, including OSHA 1926.556.
3.2.5 Curb weight. The curb weight shall include the weight of the chassis and cab, with
all attachments, accessories, equipment (but excluding tools and augers), body, derrick and a full
complement of fuel, lubricants, and coolant.
3.2.6 Gross vehicle weight. The gross vehicle weight (GVW) shall consist of curb
weight, operator weight (computed at 175 pounds), and a payload to provide not less than the
specified GVW; or a payload of not less than 2,500 pounds, whichever provides the greater
GVW.
3.2.6.1 Weight distribution. The distribution of the GVW for the purpose of establishing
suspension, axle, and tire capacities shall be determined with the payload uniformly distributed
over the vehicle body load area. In addition, front suspension, axle, and tire capacities shall be
not less than 9,000 pounds, measured at the ground.
3.2.7 Ratings. The vehicle and component ratings shall be the manufacturer's published
ratings. Vehicle and component ratings shall not be raised to meet the requirements of this
specification. When published ratings are not available, verification of ratings shall be available
to the engineering office of the procuring activity. Minimum GVW ratings shall conform to
1.2.1 for the specified class of vehicle. In addition, the actual GVW rating of the vehicle
furnished shall exceed the minimum GVW specified when required to provide a payload of not
less than 2,500 pounds evenly distributed over the load area.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals