Click here to make tpub.com your Home Page

Page Title: Controls and operating mechanisms
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-62316B(AT)
A coolant shutoff valve shall be provided for the coolant inlet side of the fuel
warmer unit. The unit shall not cause heating of the fuel above 27C (80F)
under any possible condition.
*
(d) An in-tank fuel warmer or preheater unit shall be provided on diesel engine
driven vehicles. The unit shall use engine coolant to transfer heat to the fuel in
one fuel tank. The warmer shall not cause heating of any fuel above 27C (80F)
under any possible condition, shall not disable or cause elimination of the fuel
gage sending unit and shall not violate 3.2.1 or any Federal Motor Carrier Safety
Regulation. A coolant shut off valve shall be included. The units required by
3.4.17(c) and (d) may be combined.
3.4.18 Heater and defroster. The vehicle shall be provided with a hot water heater with
fresh air intakes and discharge outlet to floor and to windshield defroster louvers. The heater
shall be complete with blower and mounted controls convenient to the driver.
3.4.19 Controls and operating mechanisms. Controls and operating mechanisms shall be
located for left hand drive. Controls shall be complete and conveniently operable by the driver.
Lever controls shall be designed and located to permit easy entrance and exit of operator to and
from the driver's compartment. Instruments and controls shall be identified as to their function
and installed in a manner to facilitate removal and servicing. Instruments shall be panel mounted
and visible to the driver when seated in the driving position.
*  3.4.19.1 Accessories and equipment. Chassis equipment shall be complete with all
accessories furnished as standard equipment by the manufacturer. The following minimum
equipment shall be furnished:
(a)
Key-operated ignition switch
(b)
Ammeter or charging indicator
(c)
Fuel gage
*
(d)
Oil pressure gage or red indicator warning light
*
(e)
Engine coolant temperature gage or high coolant temperature or low coolant level red
indicator light
(f)
Speedometer with recording odometer
(g)
Ash receptacle, permanently attached
(h)
Two padded sunvisors
(i)
Front door mounted armrests on driver's and passenger's side
(j)
Driver's compartment ventilator other than window
(k)
Dome light switch operable from driver's seat
(1)
Cargo compartment domelight with switch operable from the driver's area and at the
rear doors. Three-way switches shall be provided.
13

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business