Click here to make tpub.com your Home Page

Page Title: Crew cab
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-62320C
3.4.16 Tool stowage. Stowage space of sufficient size to accommodate a vehicle jack, hand
tools, antiskid chains and emergency reflective triangles shall be furnished for retaining
equipment during vehicle operation. Stowage space for these tools may be furnished in the cab.
When stowage space for these tools is located outside the cab, it shall be weatherproof and shall
provide for locking with a padlock.
3.4.16.1 Tools. When specified (see 6.2), each vehicle shall be furnished with tools required
for exchanging a mounted tire assembly with the spare assembly, and shall include at least a
hydraulic jack, jack handle, and wheelnut wrench. The jack shall be of such closed height as to
permit its location under an axle or other satisfactory lift point, at any wheel with a tire flat. The
jack, without blocking, shall be capable of raising any wheel of the loaded vehicle to a height
adequate to permit removal and replacement of the wheel and tire assembly.
3.4.17 Heater and defroster. A hot water heater shall be provided. The heater shall have
fresh air intakes. Discharge outlets shall be provided to direct heated air to the floor and to the
defroster louvers. The heater shall be complete with a blower and with mounted controls
convenient to the driver.
3.4.18 Controls and operating mechanisms. All controls and operating mechanisms shall be
located for left hand drive. Controls shall be complete and conveniently operable by the driver.
Lever controls shall be designed and located to permit easy entrance and exit of the operator to
and from the driver's compartment. Instruments and controls shall be identified as to their
function and installed in a manner to facilitate removal and servicing. The instruments shall be
panel mounted.
*  3.4.19 Accessories and equipment. Chassis equipment shall be complete with all accessories
furnished as standard equipment by the manufacturer. The following minimum equipment shall
be furnished:
(a)
Key operated ignition switch
(b)
Ammeter, charging indicator or voltmeter
(c)
Fuel gage
(d)
Oil pressure gage or red indicator warning light
(e)
Engine coolant temperature gage or high coolant temperature or low coolant level red
indicator warning light
(f)
High coolant temperature or low coolant level alarm buzzer
(g)
Speedometer with recording odometer
(h)
Ash receptacle
(i)
Dual sunvisors
(j)
Front door mounted armrest on driver's side
(k)
Driver's compartment ventilator other than window
(l)
Tachometer (for diesel engine driven vehicles).
19

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business